Luxman C-700u, Руководство пользователя

Страница: 15 / 32

CONTROL AMPLIFIER C-700u
13
Before Connecting
Before connecting other devices, connect the jack side of the
accessory power cable to the AC inlet of this unit.
Before connection, turn off the main power switch of this
unit and the power of all other connected devices to prevent
unexpected accidents that may be caused by noise.
How to connect power supply
Use the accessory power cable and insert the AC plug in an
outlet on the wall in the room where the unit will be installed.
How to connect the input terminals to
input devices such as a CD player
Connect the output terminals of an input device such as a CD
player to the input terminals of this unit with pin-plug cables
or balanced cables.
In connecting, take great care not to connect the right and
left channels reversely. If these are connected reversely the
localization of sound images is deteriorated and proper play-
back is not acquired.
In case of using pin-plug cables, If the ground side of pin-plug
cable is floating, it may cause generation of noises like hum,
deterioration of S/N ratio. Be sure to insert the plug securely.
How to connect the output terminals to
output devices such as a power amplifier
Connect between the input terminals of an output device
such as a power amplifier and the output terminals of this unit
with pin-plug cables or balanced cables.
In connecting, take great care not to connect the right and
left channels reversely. If these are connected reversely the
localization of sound images is deteriorated and proper play-
back is not acquired.
In case of using pin-plug cables, If the ground side of pin-plug
cable is floating, it may cause generation of noises like hum,
deterioration of S/N ratio. Be sure to insert the plug securely.
How to connect the remote output
terminal to a power amplifier
Connect the remote input terminal of a power amplifier such
as Luxman M-700u to the remote output terminal of this unit
with the dedicated remote cable (no polarity) attached to the
power amplifier.
Through the connection, the power of the power amplifier can
be turned on and off by the operation switch of this unit.
Two (2) remote output terminals are available, and both ter-
minals provide the same signals. Use them according to your
taste.
Use the dedicated remote cable only for the connection be-
tween Luxman control amplifiers and Luxman power amplifi-
ers. Connection to such a terminal that the remote output of
this unit is short-circuited may cause a malfunction.
When this unit is connected to an output device, turn off the
main power switch of this unit or turn this unit to the standby
state to protect the amplifier and speakers from excessive
input, and turn off the power of the input/output devices con-
nected to this unit. After connection, confirm that connec-
tions are appropriately done and turn this unit and the input/
output devices to the operating state.
How to connect a recorder
Connect the input terminals of a recorder to the record output
terminals of this unit with pin-plug cables.
Through the connection, while listening to a sound source
selected by the input selector, it is possible to record the lis-
tening source at the same time. Next, connect the output
terminals of the recorder to the monitor input terminals of this
unit with pin-plug cables. Then, press the monitor switch of
this unit, it is possible to listen the recorded source and check
the recording condition at the same time.
In connecting, take great care not to connect the right and
left channels reversely. If these are connected reversely the
localization of sound images is deteriorated and proper play-
back is not acquired.
If the ground side of pin-plug cable is floating, it may cause
generation of noises like hum, deterioration of S/N ratio. Be
sure to insert the plug securely.