Luxier
SP26-CEC
Rev. A 022020
3
Attention
•
This installation guide is subject to change without notice, please contact us to request the most
updated version of this installation guide.
•
This is a general installation guideline, actual installation may vary. Consult a professional if
necessary.
•
Product drawings in this installation guide is for illustration purpose only. Actual product may vary
depends on model.
•
Always take extra precautions and wear appropriate safety equipment when installing this product.
•
Proper water pressure needs to be maintained to prevent possible scalding.
•
Stainless steel shower panels are handmade and assembled. Product dimensions may vary
slightly, always measure the actual product before installation.
•
This product is equipped with a water saving device with restricted fl ow rate as required by the
state of California. To learn more about this water saving feature, please contact our customer
service department.
You may also need the following tools
1. Thread Sealant Tape, (PTFE Tape)
5. Pencil or Marker
2. Silicon Sealant
6. Level
3. Screw Driver Set
7. Hammer
4. Drill with ¼” Drill bit
Before You Begin
•
Read and understand this instructions completely before installation.
•
Unpack and inspect the shower panel from the package for shipping damage and make sure all
parts are included with the shower panel.
•
Keep the product in its package until you are ready to install.
•
Read and understand this installation guide completely.
•
Make sure the installation site is clean and free of dust and debris.
•
Please make sure the water supply is shut off to the installation area. If necessary, shut off the
water to the entire house.
•
Turn on the water at a bathroom faucet in the house to relieve the pressure in the plumbing
system.
Rough-In
•
Please follow all local building and plumbing codes.
•
The height and placement of the shut off valves will be based on the installation height of
the shower panel, see fi gure A. The installation height is approximately the total distance of
measurement A and measurement B.
•
The fi nished wall opening for the valves should not be larger than 4.5” wide by 6” tall. Make sure
the opening is completely waterproof to prevent any water leaking into the wall space. (NOTE:
Product warranty does not cover any damages caused by water leak due to negligent and
improper installation of the shut off valves and the shower panel.)
•
An outlet box such as the Sioux Chief Ox Box
TM
696-2 is recommended to expedite the installation
process of the shut off valves. (NOTE: additional parts such as 1/2” angle valves, 5/8” rubber
grommets, and other parts are required but not included with this product.) Refer to Appendix A for
detail diagram for the outlet box.
