LX114
V. 01 – 18/09/2014
7
©Velleman nv
7.4
Other Settings
Dimmer
The dimmer menu allows you to select a specific dimming curve.
1.
Press MENU until <DIM MODE> is displayed and press ENTER.
2.
Use UP or DOWN to select the dimming curve (OFF, DIM1, DIM2 or DIM3) and press ENTER to
confirm.
3.
Press MENU to quit.
White Balance
The white balance menu allows you to adjust the RGB parameters and to make different hues of white.
1.
Press MENU until <WHITE> is displayed and press ENTER.
2.
Use UP or DOWN to select warm white (W) or cold white (A) and press ENTER to confirm.
3.
Use UP or DOWN to set the value from 0 to 255.
4.
Press MENU to quit.
7.5
Other Settings
Auto Test
This function allows you to check the device automatically.
1.
Press MENU until <INFO> is displayed and press ENTER.
2.
Use UP or DOWN to select <AUTO TEST> and press ENTER.
3.
Press MENU to quit.
FixHours
This function shows the working hours.
1.
Press MENU until <INFO> is displayed and press ENTER.
2.
Use UP or DOWN to select <FIXHOURS> and press ENTER.
3.
The display will show the working hours.
4.
Press MENU to quit.
Version
This function shows the firmware version.
1.
Press MENU until <INFO> is displayed and press ENTER.
2.
Use UP or DOWN to select <VERSION> and press ENTER.
3.
The display will show the firmware version.
4.
Press MENU to quit.
7.6
DMX Mode
This mode allows you to control the device by any universal DMX controller.
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to “listen” to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
When all devices have the same address, all the units will “listen” to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will “listen” to a separate channel
number. Changing the settings of one channel will only affect the device in question.
In case of the 2-channel mode, you will have to set the start address of the first unit to 1 (CH1–2),
the second to 3 (1 + 2) (CH3–4), the third to 5 (3 + 2) (CH5–6), and so on. The highest start
address is 511.
In case of the 3-channel mode, you will have to set the start address of the first unit to 1 (CH1–3),
the second to 4 (1 + 3) (CH4–6), the third to 7 (4 + 3) (CH7–9), and so on. The highest start
address is 510.
In case of the 7-channel mode, you will have to set the start address of the first unit to 1 (CH1–7),
the second to 8 (1 + 7) (CH8–14), the third to 15 (8 + 7) (CH15–21), and so on. The highest start
address is 506.
To set the device to work with a DMX controller:
1.
Press MENU until <CHANNEL> is displayed and press ENTER.
