LuxHome LHC100SK, Инструкция по эксплуатации

Страница: 26 / 43

6
b) Using a Remote Control:
With the required House Code already set in the remote, press the DISARM button on the
Remote Control.
The Control Panel will beep twice to acknowledge the signal.
The Zone, Fire and Tamper LED status will be updated to correspond with the House Code set on
the Remote Control and now programmed into the Control Panel.
Press
,
1 2 3 4
,
to return to programming mode.
Instant Delay Zones
Default setting: Zone 1 Delay
Zones -6 Instant
Press
,
1 2 3 4
,
The zone LEDs corresponding to the zones currently set to Delay will be illuminated. LED’s for zones
set to Instant will be OFF.
LED ON Delay Zone
LED OFF Instant Zone
To change the settings of a zone press the button corresponding to the zone number. The zones will
switch to the opposite mode each time the button is pressed.
Press
,
1 2 3 4
,
to save the new setting and return to programming mode.
Press
ESC
!
to return to programming mode without saving.
Entry / Exit Delay
Default setting: 30 seconds
Press
,
1 2 3 4
,
The zone LED corresponding to the current setting will illuminate.
0 no delay, (i.e. Instant)
1 10 seconds
0 seconds
3 30 seconds
4 40 seconds
5 50 seconds
Press the key corresponding to the required delay setting required, the corresponding zone LED will
illuminate as the setting is changed.
Press
,
1 2 3 4
,
to save the new setting and return to programming mode.
Press
ESC
!
to return to programming mode without saving.