Product Name:
Polyresin Fountain with LED light
SKU #:
WHF1434-B
Instruction Manual
SAVE THESE INSTRUCTIONS
–This manual contains important
safety and operating instructions for power units.
•
Check the water level regularly to ensure the pump is completely submerged during operation. The pump should be
fully submerged during operation. Do not add water while operating the product. Always disconnect the pump from the
power source before adding water.
WARNINGS:
•
To reduce the risk of electric shock, connect only to a properly grounded, grounding type receptacle.
•
To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 feet in any
dimension.
•
Do not exceed the voltage shown on the pump.
•
Always disconnect the pump from the power source prior to beginning any maintenance or work on the pump or
fountain.
•
Inspect the power cord for damage before installation and/or maintenance. Replace the entire pump if damage is
found.
•
For pumps with a 3-prong, grounded type plug, do not remove the grounding pin from the plug on the power cord.
TIPS AND TROUBLESHOOTING:
1. Ensure that the pump’s flow control switch is set to maximum (+) before operating. Once the flow is established, the
pump can be adjusted downward to the desired level.
2. If the pump operates, but there is no flow, check to ensure the pump is fully submerged.
3. If the pump operates, but there is no flow, check the supply tubing for kinks and correct.
4. If the pump operates, but there is no flow, and if the pump is submerged and there are no kinks in the supply tubing,
lift the pump from the water. Remove supply tubing at pump outlet and clean tubing inside and out if necessary. Reset
pump in water (outlet side up) and once water begins to flow, re-attach the supply tubing.
