Product Name:
Birds and Pedestal Stone Finish Patio Fountain with LED Lights
Instruction Manual
SAVE THESE INSTRUCTIONS
–This manual contains important
safety and operating instructions for power units.
Thank you for purchasing this product. This product has been manufactured with the highest standards of safety
and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from inside the carton to ensure there are no missing or damaged parts. If any parts are missing
or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain Top Cover
1
Fountain
1
Pump w/ Adaptor
1
Compatible Pumps for this fountain:
Pump Model No.
JR250/LED
JB333/LED
YH300-70/LED
Tools required for assembly:
No tools required for assembly.
Assembly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Place the pump upright inside the top of the main fountain and draw the pump power cord through the tube
and out the fountain back. Connect the water tube attached to the underside of the fountain cover to the
electric pump. Connect and tighten the LED cable to the LED connector on the pump.
①
4. Place the fountain top inside the top of the fountain, and make sure the water tube is properly connected with
the pump and is not crimped.
5. Add clean water into the fountain.
②
The water level should be approximately 30mm lower than the edge of
the basin. (Please refresh the water weekly to help maintain the fountain.)
6. Connect the pump power cord to a ground fault circuit interrupter (GFCI) outlet and the product will begin to
function as intended.
③
7. If installed properly, water flow in the fountain will begin shortly.
8. Adjust the flow rate (if applicable) to the maximum (+) position. If necessary, readjust the flow rate to the
desired level (remember to always disconnect from the power source before handling the pump).
9. Please do not use the electrical plug during wet weather conditions. Please note: On first use, there may be
air in the pump. It may take several minutes until all the air escapes.
10. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an area where it
cannot be damaged. Check the area around your fountain on a regular basis to ensure that there is no
leakage.
11. Do not leave your fountain running for extended periods of time when no one is present to observe the
