LUXE
Bidet
LUXE
Bidet
LUXE
Bidet
LUXE
Bidet
LUXE
Bidet
LUXE
LUXE
LUXE
LUXE
LUXE
Connecting the hot water supply hose.
If you have trouble pushing the polyurethane hose onto the t-adapter, hold the
hose end under hot running water to expand it slightly and try again. If you need
a hose longer than 10 feet, you may purchase a 16 foot 8 mm polyurethane
hose at www.LuxeBidet.com/accessories.
TROUBLESHOOTING
For additional troubleshooting tips, please see our FAQs page at www.LuxeBidet.com.
Using the bidet with only cold water.
To use the bidet with only the cold water
connected, screw the bidet inlet cap included
with the accessories onto the hot water bidet
inlet. This will prevent any backflow while the
bidet is operated.
After installing the bidet, the toilet seat sits at an angle and no longer
rests on the toilet bowl.
Apply adhesive rubber bumpers to the bottom of the seat to eliminate the gap.
Bumpers are available for purchase when you go to
www.LuxeBidet.com/accessories.
When the bidet is on, no water comes out of the spray nozzle.
Solution 1: Gently pump the nozzle up and down by hand. It may simply be
stuck.
Solution 2: Check that the t-adapter has been drilled all the way through so
water can flow through it. If the t-adapter is blocked, please contact us for a
replacement.
Water is leaking from a connection.
Solution 1: Try reconnecting the t-adapter to ensure that all threads are catching
properly and that the connection is properly tightened.
Solution 2: If you have difficulty properly tightening the t-adapter, try wrapping a
thin layer of plumbing tape over the toilet tank or sink valve threads before
connecting the t-adapter. The plumbing tape will allow for added grip.
Solution 3: If you continue to experience a drip from the t-adapter or any other
connection, please contact us.
For other questions or concerns, please contact us at
www.LuxeBidet.com
OPTIONAL ACCESSORIES
Available for Purchase at www.LuxeBidet.com/accessories
Bidet
Connection
1/4”
Metal
Wing Nut
Metal T-Adapter
Connection
8 mm
16’ Polyurethane Hose
(Hot Water)
Bidet
Connection
1/4”
Metal
Wing Nut
Metal T-Adapter
Connection
8 mm
9’ Metal Braided Hose
(Hot Water)
This polyurethane hose is a longer
version of the hose included with the
bidet.
The polyurethane hose included with
the bidet for hot water connection can
be replaced with this 9’ metal braided
hose. Please note that the length
cannot be adjusted.
1/2”
Wing
Nut
8 mm
1/2”
Sink Hose
Connection
Sink Water
Connection
(Wall Outlet)
Bidet Hose
Connection
Metal T-Adapter
(Hot Water)
Rubber Washer
Some households have a 1/2” hot
water connection rather than the
provided 3/8”.
15/16”
15/16”
1/2”
Rubber Washer
Toilet Tank Connection
Bidet Hose
Connection
Toilet Hose Connection
Metal T-Adapter
with Shut-Off Valve
(Cold Water)
Shut-Off
Valve
This metal t-adapter has a shut-off
valve to limit or cut off cold water to
the bidet. It can be used instead of the
plastic t-adapter for the cold water
connection.
2Go Products, LLC
C
For more information, visit www.LuxeBidet.com.
Assembly Instruction
LUXE
Bidet
R
TM
LUXE
Bidet
R
TM
NEO250 & NEO320
