035-18200-000-B-1102
Unitary Products Group
3
GENERAL
Every unit includes a well-insulated cabinet, copper
tube/aluminum
fin
coil
with
interlaced
circuiting
arrangement, 1" throwaway filters, centrifugal blower
with a fixed pitch sheave, and a blower motor with vari-
able pitch sheave.
They also include 2 filter driers, 2 expansion valves
and distributors that are only used during the cooling
cycle plus a check valve to provide the proper flow of
refrigerant through the unit during both the cooling and
heating cycles...
The controls include 208/230/460 volt transformer,
blower motor contactor and relay, and a low voltage
terminal block.
The units are shipped in the vertical position ready for
field installation. For horizontal installation, the blower
module can be repositioned in the field as shown on
page 3 for maximum flexibility. *Blower motor and drive
sold separately on FHP240.
RENEWAL PARTS
Refer to the Source One Parts Manual for a complete
listing of replacement parts on this equipment.
All forms referenced in this instruction may be ordered
from:
Standard Register
2101 West Tecumseh Road
Norman, Oklahoma 73069
Toll Free Fax (877) 379-7920
This instruction covers the installation of the indoor
unit. For information on the installation and operation of
the matching outdoor unit, refer to part no. 035-17399-
000.
Installer should pay particular attention to the words:
NOTE, CAUTION and WARNING. Notes are intended
to clarify or make the installation easier. Cautions are
given to prevent equipment damage. Warnings are
given to alert the installer that personal injury and/or
equipment damage may result if the installation proce-
dure is not handled properly.
INSPECTION
As soon as a unit is received, it should be inspected for
possible damage during transit. If damage is evident,
the extent of the damage should be noted on the car-
rier’s freight bill. A separate request for inspection by
the carrier’s agent should be made in writing.
Improper installation may create a condition
where the operation of the product could
cause personal injury or property damage.
This product must be installed in strict compli-
ance with the enclosed installation instruc-
tions and any applicable local, state, and
national codes including but not limited to,
building, electrical and mechanical codes.
FIGURE 1: PRODUCT NOMENCLATURE
E
A
S E
-
T
8
A
PRODUCT NOMENCLATURE
PRODUCT GENERATION
A = 1st Generation
PRODUCT CATEGORY
F = Split-System Heat Pump
Indoor - 4 Pipe Unit
PRODUCT IDENTIFIER
SE = OUTDOOR UNIT
VOLTAGE CODE
-T = 208/230-3-60
NOMINAL COOLING
CAPACITY (@ 60 Hz)
180 =
240 = 20 Ton
FACTORY INSTALLED
HEAT
A = No Heat Installed
1
0
15 Ton
-W= 460-3-60
4 PIPE
B = 2nd Generation