LuxaFlex EVO MagnaTrack, Руководство по установке

Страница: 30 / 33

30 | P a g e
The filling of the fabric on the idle end requires the tube to be lifted out of the bracket
to provide room for the bottom rail to be fed into the funnel from the top.
NOTE: This can be very heavy, it is recommended one fitter holds the weight of the
blind while the other fitter feeds the bottom rail into the screen guide.
1. Remove the retainment pin on the idle end (fig R1 and R2)
2. Lift the idle end out of the bracket (fig R3)
3. Manually lift the bottom rail and feed the keder into the funnel (fig R3)
4. Lower the bottom rail into the Evo MagnaTrack Channel (fig R4 & R5)
5. Replace the idle end in the bracket with the retainment pin (fig R6)
I. Secure the probes so bottom rail won’t rub on the screen guide.
• Using the longer screws from the “probe bag”
secure the motor end probe after running the
blind up and down a few times. Ensure probe or
bottom rail is not rubbing on screen guide. Secure
55mm from end of bottom rail.
• Do not secure the probes under 55 mm from each
end of the bottom rail as the screw will slip
because it will catch the slot for the keder.
• If the screw needs to be refastened, go to 65 mm
from end of bottom rail.