LuxaFlex EVO MagnaTrack, Руководство по установке

Страница: 16 / 33

16 | P a g e
STEP 3
Fasten probes onto the keder.
• Start on Idle side.
• Remove the screws from the probe.
• Fold the keder out of the way.
• Insert the probe into the bottom rail.
• Release the keder and slide the probe out of the bottom rail while guiding the
keder flaps into the slot.
• Ensure the flap of the keder is fully inside the slot on the probe before securing
(fig B1).
• Fasten the probe screws into the keder flaps (fig B2).
• Slide the bottom rail over the probe and screws 12-22 mm so the probe can be
installed on the other side, then repeat the process (fig B3).
Note the brush will also slide in the bottom rail.
• Slide bottom rail back to the middle position once both probes are located
inside the bottom rail and secured to the keder.