LUX 468428, Оригинальное руководство пользователя, Страница: 11 / 26

11
Operation
Check before starting!
Check the safe condition of the device:
– Check whether there are any visible
defects.
– Check whether all parts of the product
are firmly attached.
– Check that the safety devices are in fault-
less condition.
Setting the operating modes
Adjusting the cutting height
► P. 4, item 4
– Adjust the cutting height as shown in the
figure.
– Observe the data on the cutting height
unit.
Attaching the extension cable
► P. 5, item 7
– Hook in the extension cable as illustrated.
Starting the device
► P. 5, item 5
– Press the safety lock (15) and keep it
pressed.
– Pull and keep hold of the switch-on
lever (2).
• The product starts up.
Switching the device off
– Release the switch-on lever (2).
• The product stops.
Information on mowing
• Steer the product at an even, slow speed
(walking pace) in the straightest lines
possible.
• Always work across slopes where possi-
ble.
• Do not cut wet grass if possible.
• Overlap the mowing lines slightly for an
even appearance.
►
P. 5, item 9
– With the flow flap closed, check whether
the collecting sack is full and empty it if
necessary.
Cleaning and maintenance
WARNING! Risk of injury! The
product must only be put into opera-
tion if no defects or errors are found.
Ensure that any defective parts are
replaced before the product is used
again.
WARNING! Risk of injury! Always
pull out the mains plug (disconnect
the product from its power supply)
before commencing work on the
product.
NOTICE! Product damage! Only
cut long grass with the product set at
it’s highest setting and by repeating
the working processes until the grass
is at the required height. This will pre-
vent overloading the product.
NOTICE! Product damage! Before
commencing work always make sure
that the product has reached its
maximum speed.
Note: When the switch-on lever (2)
has been pulled and the product is
running, the safety lock (15) can be
released.
WARNING! Risk of injury! –Always
keep the extension cable away
from the product.
– Should a foreign body jam the
cutter, release the switch-on
lever (2) immediately.
– If a foreign body gets trapped,
check the product and have it
repaired if necessary.
DANGER! Danger of death! Before
any maintenance and/or cleaning
work:
– Switch off the product.
– Pull out the mains plug.
WARNING! Risk of injury! Cutter
runs on!
– Never tilt, lift or carry the product
while the motor is running.
– Wait until the product has come
to a standstill before commenc-
ing any maintenance and/or
cleaning work.
GB