69
Letting the saw chain run in
During the run-in time, re-tension the saw chain and rail after a maximum of 5 cuts.
Checking the tensioning of the saw chain
The saw chain is tensioned correctly if it lies close against the underside of the saw rail and can be
moved easily by hand.
Readjust tension of the saw chain when necessary (
Re-tensioning the saw chain – p. 76).
Checking the chain greasing
The device may not be used without sufficient chain greasing. Insufficient greasing reduces the service
life of the device.
– Check the oil quantity in the tank.
– Start the device.
– Hold the running saw chain approx. 15 cm over a suitable surface for a time (15 sec.).
If there is sufficient chain greasing, the oil spraying off of the saw chain will form a slight trail.
Filling up saw chain oil
– Lay device securely with the tank cover (9) upwards.
– Before opening, clean the tank cover and the filler neck if necessary.
– Slowly open and remove the tank cover.
– Carefully fill up the saw chain oil. Do not spill!
– Tighten the tank cover by hand.
– If you have spilled any saw chain oil, be sure to wipe it up.
Operation
Safety equipment
The device has several pieces of safety equipment which reduce the risk of injury when working:
Attention!
Environmental damage!
Since the saw chain oil can penetrate the environment during operation, biologically-degra-
dable special vegetable-based saw chain oils should be used.
Kettensaege_Akku_467351.book Seite 69 Mittwoch, 25. August 2010 10:19 10