Lux Tools 258218, Оригинальное руководство пользователя

Страница: 23 / 96

GB
23
Assembly
►
P. 4, item 2
– Screw the cable pull unit to the support pipe (5):
Place the securing clamps (4) on the support
pipe and screw firmly using screws (14) with the
housing (10) of the cable pull unit.
Mounting the lifting block
►
P. 4, item 3
– Hang the hook (3) into the eye (14).
►
P. 5, item 4
– Release the screw connections (15, 16) on the
lifting block (1).
►
P. 4, item 3
– Thread the steel rope (13) into the lifting block (1)
as shown.
►
P. 5, item 4
– Ensure that the steel rope (18) lies up against the
pulley and does not jam.
►
P. 5, item 4
– Mount the hook (19) using screw and nuts (15)
plus rubber rings (17) into the lifting block (1).
►
P. 5, item 4
– Screw the screws (16) with nuts back into place.
Using for the first time
– Before using for the first time, completely extend
and retract the steel rope with no load in order to
ensure the functionality of the end switch.
– To do this, push the switch (8) on the control
unit (9) down.
– Then push the button (8) up until the steel rope is
fully wound again.
Operation
Check before starting the device!
Check the safety equipment and make sure the
device is safe for operation:
– Check to make sure there are no visible defects.
– Check to make sure all unit components are cor-
rectly mounted.
– Check to make sure the safety equipment is func-
tioning properly.
Lifting and lowering
Cleaning and maintenance
Cleaning and maintenance overview
After each use
DANGER! Risk of injury during assem-
bly!
Assemble the cable pull unit only to the
prescribed arm or swivel arm.
Parts may only be installed and remove
when the the motor is switched off.
Note: If possible, use two people to carry
out the assembly.
Note: Observe the combination options
with swivel arms (
►
Technical data –
p. 24
).
For cable pulls which may be mounted to an
extension with a thinner support pipe, the
supplied rubber bearings must be used
between the securing clamps and the sup-
port pipe.
Note: Self-securing nuts with a plastic
insert must be replaced after they have
been used once.
DANGER! Risk of injury!
The device may
only be put into operation if there are no
defects. If a part is defective, it must be
replaced before the machine is used again.
NOTICE! Risk of damage to the unit! If
an unusually loud noise is generated when
lifting, the unit is either overloaded or defec-
tive.
►
P. 5, item 5
The steel rope must always be wound
tightly and parallel as shown in the diagram.
DANGER! Risk of injury!
►
P. 5, item 6
Before each use, the steel rope (13) must
be subjected to visual check for damages.
These may appear as shown in the dia-
gram.
Note:
The cable pull has end switches and
automatically brakes at both the maximum
lift height and when the steel rope is fully
unwound.
The unit is protected from overheating and
switches itself off in the event of increased
operating temperatures.
DANGER! Risk of injury! Prior to con-
ducting maintenance or cleaning:
– Unplug from the power source.
– Allow the device to cool down.
DANGER! In the interest of your own
safety!
Carry out only the maintenance
work described here in person.
All other work, in particular motor mainte-
nance and repair, must be carried out by a
trained specialist. Improper maintenance
work can damage the device and lead to
injuries.
What? How?
Clean the device.
►
Cleaning the device –
p. 24