Lux Tools 196062, Руководство пользователя

Страница: 40 / 156

GB
40
Assembly
Mounting the handle
►
P. 4, item 3
– Tighten the lower section of the handle (4)
as shown using the carriage bolts (17)
and toggle nuts (18) on the unit.
►
P. 5, item 4
– Tighten the handle (3) using the clamping
lever screws (19) and knurled screws (20)
on the lower section of the handle.
– Press the clamping lever towards the han-
dlebar.
– If the clamping lever does not safely
clamp: open the clamping lever again in a
clockwise direction and tighten it to the
limit stop.
– If the clamping lever cannot be tightened
to the limit stop: open the clamping lever,
make a counter-clockwise revolution, and
tighten it to the limit stop.
Mounting the collection box
►
P. 5, item 5
– Attach the collection bag (21) to the col-
lection basket upper (22).
– Press the rubber lip as far as possible into
the guide!
Using for the first time
Charging the battery pack
• The battery pack must be charged prior to
the first start-up (charging time:
►
Techni-
cal data – p. 43 ).
– Press in the locking button (14) and
remove the battery from the device.
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (15).
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
– Press the button (13).
The remaining capacity of the battery is dis-
played by the control lights (12).
Preparation
Set the cutting height
The cutting height can be set to several differ-
ent heights (Cutting heights:
►
Technical
data – p. 43
).
►
P. 6, item 8
– Pull the lever (6) to the side.
– Set the cutting height to the value you
require, and let the lever slot back into
place.
Attach the collection box
►
P. 7, item 9
– Lift the protective flap (9) and hold.
– Hook in the collection box (5).
– Make that the collection box is securely
engaged.
Mounting the ejection opening
►
P. 7, item 10
– Lift the flap (25).
– Hook on the ejection opening (7).
Mounting the mulch wedge
►
P. 8, item 11
– Remove the collecting sack.
– Push the mulch wedge (26) into the open-
ing of the machine until it engages.
Note: All mounting steps must be
performed on both sides.
WARNING! Risk of injury! Comply
with all safety instructions when han-
dling rechargeable devices.
NOTICE! Risk of damage to the
unit!
Due to the high operating cur-
rent, the unit must only be operated
with batteries with a capacity of at
least 4 Ah (article number 196052).
Replacement batteries with article
number 196051 are not suitable for
operation with this unit.
NOTICE! Risk of damage to the
unit!
Do not allow the battery pack to
deep discharge.
Note:
The Li-Ion battery pack can be
charged at any time without affecting
the lifetime of the unit. Interrupting the
charging process will not damage the
battery pack.
Note:
When the ejection opening is
used, the mulch wedge and collecting
sack are not required.
Cut material is distributed on the
grass.
Note: Mulching is the use of cut
grass as a natural compost. When
mulch-mowing, the grass is cut, finely
chopped and spread across the
grass in one operation.