Luvion ICON LONG RANGE, Инструкция по эксплуатации

Страница: 9 / 40

9 LUVION
Premium Baby products
charged.
4.
As soon as the battery runs out of power, every 30 seconds 2 short beeps are emit-
ted. Connect the adaptor to recharge the batteries.
2. HOW TO USE
2 .1 Baby unit
1.
Hold down the menu button(3) to power the Baby unit on or off .
2.2 Parent unit
Before switching on, make sure the Parent and Baby unit are at least one metre from
each other. Any closer and you might get audio feedback sounds.
1. Press a few seconds on the power button (10) to power on and off the parent unit.
2.3 Channel and Sub-Code
Make sure the Parent unit and the Baby units are set to the same channel and Sub-code
(see chapter 4.3).
3. USING YOUR LUVION ICON LONG RANGE BABY MONITOR
3.1 Listening to your baby
1.
As soon as the Baby units detects any sound, it transmits this sound to the parent
unit. The display on the baby unit shows ‘TX’ while it is transmitting.
2. As soon as the Parent unit receives this signal, the speaker is enabled and you will
hear the sound from the baby room. ‘RX’ appears on the display of the parent unit
while receiving.
3.2 Volume
1. Repeatedly and briefl y press the button on the Parent unit to increase the
volume.
2.
Repeatedly and briefl y press the button on the Parent unit to decrease the
volume.
3.
The volume level is indicated on the display.
Note: While setting the volume a high tone is emitted. Upon reaching the minimum or
maximum volume, a low tone is emitted.
3.3 Nightlight
1. Briefl y press the or button on the Baby unit to switch on the nightlight
on the Baby unit.
2.
Briefl y press the or button again to switch off the nightlight on the Baby
unit.
Note:
When the nightlight is on, the display lighting of the Baby unit is switched on, but
the display shows no further information. Only the nightlight icon is illuminated. While the
nightlight is on, it is not possible to adjust any settings in the menu.
3.4 Flashlight
1.
Briefl y press the button on the Parent unit to switch the fl ashlight on (9).
2. Briefl y press the button again to switch the fl ashlight off (9).
Note: The fl ashlight only works when the Parent unit is switched on.
EN