Luvion ICON LONG RANGE, Инструкция по эксплуатации

Страница: 10 / 40

10
4. SETUP
4.1 Baby unit
Menu fl ow goes as follows for the baby unit once you push the menu button:
Channel & Sub-code > VOX Sensitivity > Auto Monitor > Exit menu
On the Baby unit, the following settings can be adjusted:
• Send channel: this is the frequency at which the baby unit transmits. You can
choose from channel 1 ~ channel 8.
• Sub code: this option adds an extra code to the signal allowing you to only listen
to your baby unit without interference from other transmitters on the same fre-
quency.
•
VOX: This allows you to determine how loud the baby must cry before the baby
units starts transmitting to the parent unit. At VOX setting 1 the baby must cry
loudly before the sound is transmitted to the parent unit. At VOX setting 4 also
(very) soft baby sounds are transmitted. It will require some experimenting to fi nd
your ideal VOX level.
•
Auto monitor: see chapter 5.3 of this manual for the description of this function.
1.
Insert the Baby unit into wall socket.
2.
Briefl y press the button and use the or button to set the send channel.
3. Briefl y press the button and use the or button to set the send sub code.
4.
Briefl y press the button and use the or button to set the send the VOX
sensitivity.
5.
Briefl y press the button and use the or button to enable or disable the
‘Auto Monitor’ function.
6.
Briefl y press the button to save your settings and to fi nish the setup.
Note: When the nightlight of the baby unit is switched on, you CANNOT change the set-
tings. First press the or button to switch off the nightlight. The setup menu will auto-
matically disappear from the screen if you do not press a button for a while.
4.2 Additional Baby Unit #2 or #3
Use a diff erent channel for each Baby unit when using 2 or 3 baby units. The other set-
tings can be freely adjusted.
4.3 Parent Unit
You set up the parent unit as follows:
1.
Briefl y press the ON/OFF key (10) button to enter the settings menu, 1 appears
in the display (this means baby unit 1). Use the or button to indicate whether
baby unit 1 is present.
2.
Briefl y press the menu button (11) and choose to turn it ON or OFF by using the
or button and then press menu briefl y in order to set the same send channel
as you have set for baby unit 1 by also using the or button.
3. Briefl y press menu button (11) and use the or button to set the same sub
code as you have set for baby unit 1.
4.
Briefl y press menu button (11) to indicate whether baby unit 2 is present.
5.
Briefl y press the menu button (11) and choose to turn it ON or OFF by using the
or button and then press menu shortly in order to set the same send channel as
you have set for baby unit 2 by also using the or button.
6.
Briefl y press menu button (11) and use the or button to set the same sub
code as you have set for baby unit 2.
7.
Briefl y press menu button (11) again to indicate whether baby unit 3 is present.