Luvion 75 PRO, Инструкция по эксплуатации

Страница: 9 / 54

9 LUVION
Premium Baby products
INSTRUCTION MANUAL
Luvion Icon Clear 75 Pro baby monitor safely and with pleasure. Before using the baby monitor,
we recommend that you read this manual carefully. We ask for your extra attention for the safety
instructions.
SAFETY INSTRUCTIONS
•
WARNING: CHOKING HAZARD - Keep the adapter cables out of the reach of children!
NEVER place the baby monitor or adapters within 1.5 meters of the crib / bed or a play-
ground.
•
Never use extension cables in combination with the adapters to prevent entanglement.
• Use only the originally supplied adapters. Use only on standard (100 ~ 240 volts AC) power
points.
•
If you travel abroad, check the voltage on your unit’s plugs match the local power output.
•
This product is not a toy. Don’t let children play with it.
• The baby monitor is not suitable for use as a medical surveillance monitor.
•
The baby monitor is not a substitute for parental supervision.
•
Do not use the baby monitor in a damp environment or near water, such as in the bath-
room, kitchen, laundry room or wet basement, etc.
•
This product is only suitable for indoor use.
•
It is important to fi rst check the range and condition of the baby monitor before fi rst use
and then on a regular basis.
•
Test the connection well when the baby monitor is moved.
•
Use the baby monitor at a temperature between 10 °C and 40 °C, do not place the baby
monitor in direct sunlight or at other heat sources such as radiators, candles, gas cooker, etc.
Ensure there is suffi cient ventilation space around the baby monitor.
•
Never dismantle the parent or baby unit yourself, this invalidates the warranty. This must be
done by certifi ed personnel, contact the seller of the local distributor for this.
• Only replace the batteries with original Luvion batteries of the same type. Using the wrong
batteries may damage your baby monitor.
•
Make sure that the parent unit is fully charged on fi rst use. This guarantees an optimum
battery life.
•
Dispose of used batteries in accordance with local environmental regulations.
SETUP & USE
1. PARENT UNIT SETUP
1.1 Setting up
1.
Plug one of the power cables into the socket on the back of the Parent unit. (fi g. 3)
2.
Plug the other end of the cable into your mains wall socket and switch it on.
3. Activate the batteries by pulling the plastic tab away from the back of the Parent
unit. (fi g. 4)
4.
Leave the batteries to charge for 16 hours to reach maximum charge. When they
are fully charged the battery icon on the display will show full charge.
EN