LUVERNETRUCK.COM
•
PRODUCT SUPPORT: 877.287.8634
•
570747-INS-RA
•
01/29/2021
•
ECN7969
•
PAGE 2
Step 1
Pre-assemble both driver side brackets with
spacer brackets, using the 5/16”-18 hex bolts
with 5/16” washers and 5/16”-18 flange nut.
Snug the hardware,
but do not fully tighten.
Step 2
On the back side of the rocker panel, measure about 9-1/2” back from the front
of the mud flap. There should be a body plug in this location. If the van does not
have rear A/C, scrape the under coating off around the body plug and remove the plug.
Step 4
Once the bracket is in place, the lower mount is ready to be drilled. Use an 11/32” drill bit
to drill two holes using the two holes in the lower bracket mount as a guide.
Adjust the lower bracket if needed to ensure the two holes are fully on the pinch seam.
Step 3A
After the body plug is removed, drill a 7/16”
hole 1/2” to the front of the body plug hole
and insert the 5/16”-18 U-Nut.
Place a driver-side bracket in place
using the top slot and fasten using
the 5/16”-18 bolt and washer.
Step 3B
If the van does have rear A/C, you will not need
to remove the body plug. Instead place the
pre-assembled bracket into place and mark the
hole location using the center round hole in the
bracket as a guide. Make sure that the bracket
is level with the truck.
Remove the bracket and center punch the
marked hole. Drill a 7/32” hole. Place the
bracket back in place and install the
5/16” self-tapping screw.
DRIVER SIDE INSTALLATION
