C
C
1
1.1
Addressing the system
Addressing can be done with type A, B, or C remotes.
Note
: Prior to addressing the system, all shades/drapes, by default, will respond to all IR
Remotes. After addressing, shades/drapes will not respond to any remote until it is assigned to
an IR Receiver, IR Keypad or contact closure interface.
Page 2
Enter Programming Mode
Aim the Remote at the IR Receiver
and Press and Hold Open and
Close for 5 seconds. The LED’s
on the receiving device will flash
1.2
Enter Addressing Mode
Aim the Remote at the IR
Receiver and tap Open. The LED’s
on the drive will flash rapidly until
addressed. Addressing is
complete when the receiving
device starts flashing slowly.
The addressing process will take
approximately 1 minute.
1.3
Exit Addressing Mode
Aim the Remote at the IR Receiver
and Hold Open and Close for
5 seconds. The LED’s on the drive
will stop flashing.
A
B
A
B
A
B
C
H
H
H
H
H
H
T
T
T
H
H
H
H
H
H
(H) Press and hold button
(T) Tap button
Sivoia QED
®
Favorite Preset Remote
Programming Guide
