6
adequately guarded or controlled .
5
The arbour size of wheels ,flanges ,backing pads or any other accessory must
properly fit the spindle of the power tool. Accessories with arbour holes that do not
match the mounting hardware of the power tool will run out of balance ,vibrate
excessively and may cause loss of control .
6 Do not use a damaged accessory ..Before each use inspect the accessories such as
abrasive wheels for chips and crafts ,backing pad for cracks, tear or excess wear,
wire brush for loose or cracked wires .if power tool or accessory is dropped, inspect
for damage or install an undamaged accessory, After inspecting and installing an
accessory and run the power tool at maximum no-load speed for one minute,
Damaged accessories will normally break apart during this test time .
7
Wear personal protective equipment ,Depending on application ,use face
shield ,safety goggles or safety glasses ,As appropriate,wear dust mask,
hearing protectors ,gloves and workshop apron capable of stopping small
abrasive or workpiece fragments ,The eye protection must be capable
of
stopping flying debris generated by various operations ,The dust mask or
respirator must be capable of filtrating particles generated by your operation,
Prolonged exposure to high intensity noise may cause hearing loss .
■Always wear proper personal hearing protection that conforms to ANSI
S12.6(S3.19)during use ,Under some conditions and duration of use ,noise
from this product may contribute to hearing loss .
8
Keep bystanders a safe distance away from work area ,Anyone entering
the work area must wear personal protective equipment .Fragments of
workpiece or of a broken accessory may fly away and cause injury beyond
immediate area of operation .
9
Hold power tool by insulated gripping surface only ,when performing an
operation where the cutting accessory may contact hidden wiring or its own
cord .Cutting accessory contacting a “live” wire may make exposed metal
parts of the power tool “live”and shock the operator ,Note :the above warning
may be omitted if polishing is the only recommended operation .
10 Position the cord clear of the spinning accessory .if you lose control ,the
cord may be cut or snagged and your hand or arm may be pulled into the spinning
accessory ,
11 Never lay the power tool down until the accessories has come to a complete stop ,the
spinning accessory may grab the surface and pull the power tool out of your contro ,
12 do not run the power tool while carrying it at your side .Accidental contact
with the spinning accessory could snag your clothing ,pulling the accessory
into your body .
13 Regularly clean the power tool’s air vents .The motor’s air vents .The motor’s fan
will draw the dust inside the housing and excessive accumulation of powdered metal
may cause electrical hazards.
14 Do not operate the power tool near flammable materials. Sparks could ignite these
materials
15 Do not use accessories that require liquid coolants .Using water or other
liquid coolants may result in electrocution or shock.
