Lutool LT3IN1, Инструкция по эксплуатации

Страница: 24 / 31

13 OPERATION INFORMATION SPECIFIC FOR
THE MULTI FUNCTION (OSCILLATING) TOOL
13.1 To install or remove the battery pack.(Fig. 16)
Fig. 16
1.
Turn the ON/OFF switch button of this tool to its “ OFF ” position.
2. To install, slide the battery pack into the battery port. Make sure the latches on each side of the
battery pack snap into place and battery pack is secured in the tool before beginning operation.
3. To remove, locate latches on both sides of battery pack and depress both sides to slide out battery
pack from the cordless Multi Function Tool body.
13.2 LED battery indicators (Fig. 17)
The machine has 3 LED battery indicators located on
the top of the tool.
L1:Green / L2:yellow / L3:red
The battery capacity status can be checked by
switching the tool on and pressing the ON/OFF switch
button.
The LED lights give you an idea of the capacity level of
the battery:
If all 3 LEDs are lit: The battery is fully charged.
If L1 & L2 are lit: the battery has about 60% of its
capacity left.
If only L3 is lit : the battery is almost discharged and
should be recharged.
Fig. 17
To ensure proper performance, always check if the battery is full enough for prior to operation.
NOTE : The LED battery indicators always light during operation.
NOTE : Please charge the battery after each use. If the tool is not used frequently, it is recomended to
charge the battery on a monthly basis.
13.3 Switching ON/OFF (Fig .18)
Fig.18
1.
Make sure the battery pack is installed.
2. Switch the power tool on: push the ON/OFF switch
button (2) forwards onto the “
ON ” position.
3. Switch the power tool off: pull the ON/OFF switch
button backwards to the “
OFF ” position.