1.
3.
4.
5.
Hot water
Cold water
56
A
B
2-1
2-2
2.
Hot
Cold
Close
to
H
dl
o
C
es
ol
C
Close
Open
5-1
5-2
Important Information
This product has been fully tested prior to it leaving the factory.
In some cases you may find water residue on the parts.
To ensure you get the best use from this product,
please read this installation guide thoroughly.
This product has been designed for wall mounting. The product is suitable for use on all
boiler systems including pumped, gravity and combination boilers to a maximum pressure
of 5 bar. Pressure above this may require the fitting of reducer valves.
We recommend that a fully qualified plumber install this product.
If you experience any difficulty with the installation or operation of this system,
please refer to the Troubleshooting guide.
Installation
Before installation, please make sure your system is suitable.
Mark the position of the valve and fix it in place using the screws provided.
Connect the hot and cold water feeds.
Attention: As shown in figure 2-1, the buried depth of the valve in wall is 65mm.
Take off the plastic cover after the tiling.
Carefully install the holder to the valve and screw it tight. Check leakage.
Now install the hose and douche tightly and check leakage.
PLEASE MAKE SURE YOU FULLY TEST YOUR PRODUCT BEFORE TILING ETC.
WE WILL NOT BE RESPONSIBLE FOR ANY COSTS INVOLVED IN REMOVAL OF
THE TAP IF YOU FIND THERE IS A FAULT.
Product Contents
1. Valve X 1
2. Protective cover X 1
3. Douche holder X 1
4. Douche X 1
5. Hose X 1
①
④
②
③
⑤
