Lupine Wilma R, Руководство пользователя

Страница: 17 / 23

32 33
Deut
sc
h
Engli
sh
Enable/Disable the remotes permanent LED light:
Keep the remote button depressed: The LEDs must turn green then blue again.

release the button
Low battery warning from lamphead:
The remote mirrors the lamphead's low battery warning.
A fully charged or partly discharged battery will be shown by a red LED light.
There will be no warning if the remotes button cell itself is empty.
Low button cell:
With decreasing voltage, the remotes LEDs will also become weaker, to the point the remote does not
work anymore. Also cold temperature does reduce the battery voltage.
Transmitter battery change:
For changing the battery, loosen all 4 screws at the bottom
of the transmitter using a T5 torx screw driver.
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp’s button depressed until five green LEDs light up and let the button go. The recei-
ving mode is now active for 30 seconds. During this time, press the remote control’s button until the remote
does light up green.

release the button
Several lamps and one transmitter:
It is possible to connect up to five lampheads to a single remote switch.
Several transmitters and one lamp:
Up to 4 transmitters may be connected to one lamp. The transmitter-specific codes are stored in the lamp accor-
ding to a “first in first out” principle. If you want to use only one transmitter again to control your lamp, it might
be necessary to connect this transmitter up to 4 times with the lamp until all other codes in the list will have
been overwritten.
By default, your lamp has already been connected to the transmitter.
Connecting the transmitter to the light:
Bluetooth remote control
The Bluetooth Remote comes together with the Peppi V5 barmount (helmet & bikelights) or a bracelet (Headlamps).
On the bike, the best way to mount the remote is directly next to your grips so you have full control an don't need to
take off your hands while riding. The bracelet can be attached to a lot of other things like ski poles, too.
Peppi V5 Bracelet