Lupine SL F, Руководство пользователя

Страница: 9 / 11

Operation
Keep the button
pressed until
SL lights up
(let go to select)
Lights up 1x
Lights up 2x
Lights up 3x
Lights up 4x
Lights up 5x
Lights up 6x
Delay (3 sec / 16 sec.)
Factory setting: about 3 sec.
Low beam: 8W
(Factory setting)
Low beam: 16W
Manual mode
The sensor controlled switch-
over from low beam to
daytime running light occurs
as required in either 3 or 16
seconds.
The low beam lights with 8W
(Factory setting)
The low beam lights with 16W
By pushing the wire remote
you can change between
daytime running light and low
beam. In the dark it‘s possible
to activate high beam.
Customizing the settings via the button on the bottom of the light head:
Reset to factory settings
Sensor calibration
Only in the assembled
state!
Improper calibration
may greatly affect the func-
tionality of the light!
Calibrate only outdoors. No
artificial light or close to
reflective objects!
Saves the measured bright-
ness value as a switching
point from daytime running
lights to low beam. The
successful sensor calibrati-
on is confirmed by a short
illumination of the daytime
running light.
Troubleshooting
Error
Cause Fix

The cable ends in
the light head have
been connected with
reverse polarity.

The light cable is not
connected to the drive.

The light input is not
activated in the
software.

The light does not
turn on and does
not light up

Remove the end cap of
the light head and clamp
the cable ends according
to the marking on the
gasket.

Connect the light cable.

Have the light input
activated at the
dealer.
Available settings Explanation