Luna 24752-0109, Руководство пользователя

Страница: 72 / 84

72
Trouble shooting
CAUTION: Disconnect tool from air supply before performing any service procedure.
Problem Cause Solution
Air leaking at trigger
area
1. O-ring in trigger valve stem is worn
and damaged.
2. O-ring in trigger valve head is worn
and damaged.
3. Having foreign matters.
1. Check/replaceO-ring/lubricate.
2. Check/replaceO-ring/lubricate.
3. Clean the tool/lubricate.
Air leaking at the
body lower portion
and nose
1. Screw is loose at connecting portion
of the nose and body.
2. O-ring is damaged between body
and nose.
3. Bumper is damaged.
4. Having the foreign matters at the
contacting portion of the bumper and
body.
1. Tighten screw/recheck.
2. Check/replaceO-ring/lubricate.
3. Replace the bumper.
4. Disassemble and clean.
Air leaking at the
body upper portion
and cylinder cap
1. Screw is loose at the connecting
portion of the cylinder and body.
2. Gasket is damaged.
1. Tighten the screw and recheck.
2. Replace the gasket.
Failure to start tool. 1. Tool dry, lack lubrication.
2. The spring in the cylin der cap is
damaged.
1. Use pneumatic tool oil
2. Replace the spring in the cylinder
cap.
Blade driving
fasteners too deeply
1. Safe bracket poison is not correct.
2. Air pressure is too high.
1. Rotate knob of the adjuster to move
safe bracket down.
2. Decrease air pressure.
Skipping
fasteners/feeding
intermittently
1. Having the foreign matters between
the small piston and small cylinder.
2. O-ring on the small piston is worn
and damaged.
3. Tool dry and lack lubrication.
4. The spring on the small piston is
damaged.
5. Air pressure is lower.
6. Connecting screw of nose and body
is loose.
7. Stopped hook can't stop the
fasteners.
8. Bent fasteners.
9. Wrong size fasteners.
10. Small piston bumper is worm and
damaged.
11. Feed hook is binding.
1. Disassemble/ clean/lubricate.
2. Check/replaceO-ring/lubricate
3. Use pneumatic tool oil.
4. Replace small piston the spring.
5. Increase the air pressure, but don't
exceed 120 PSI (8.3 bar).
6. Tighten all screw.
7. Replace taper spring of the stopped
hook.
8. Use recommended fasteners.
9. Use recommended fasteners
10. Replace bumper and lubricate
small piston.
11. Clean feed hook and torsion
spring.