5
TURNING THE UNIT ON AND OFF:
Your night vision unit has one-touch push-buttons. To turn the unit ON,
press the POWER Button (4) momentarily once. The LED Power
Indicator (10) located on the back of the unit should light up in green
color. Look through the eyecup (8) – you should see the Welcome
screen for a few seconds, followed by image. Even if the image is not
yet sharp, the unit is operating. To turn the unit OFF, press and hold the
POWER Button for 2 seconds. The image will disappear if you turn the
unit off correctly. We suggest to always replace the daytime color filter
/ protective lens cover after the unit is turned off and no longer in use.
IMPORTANT: When turning the unit ON or when switching between
various modes (Video, Photo etc.) or when operating the unit with Wi-Fi
stream activated, it is normal to see some image flickering in the
display. This is normal and does not affect the unit. If the flickering
does not disappear once the affecting functions are no longer active,
please re-start the unit. If conditions persist, please contact us at:
OPERATING FROM A USB POWER BANK:
Your digital viewer can also operate from the commonly available 5V
USB Power Bank chargers. Please make sure the output of the Power
Bank is at least 2A, as less powerful output may fail to power the unit
especially when the IR illuminator is activated. To connect the Power
Bank, open the Connection Area (11) rubber cover by gently pulling it
outward and then swing it counter-clockwise to the right and locate the
Micro-USB connector (11-b). Connect the small end of the USB cable
(included) to the connector and then connect the large end of the cable
into Power Bank output. You may need to activate the power bank first,
prior to turning the viewer on.
FOCUSING THE UNIT:
To obtain the sharp image, you must first rotate the Objective Lens
Focusing Wheel (1) in either direction, until you notice in which position
the image is at its best. After that, rotate the Ocular (Eyepiece)
Focusing Ring (5) also until the image is at its best. You may have to
repeat the process again, until the image is sharp and clear. Once the
clear image is obtained, you will no longer need to adjust the eyepiece,
just rotate the front objective lens to adjust the distance to the object
you are viewing.
