Lumme LU-604, Руководство пользователя

Страница: 5 / 10

5

Heater should never be used under conditions where it may be immersed, or come in contact with water. Similarly do not plug in your heater if its surfaces are damp.

Do not operate the heater with a damaged cord set, or if it has been dropped, or damaged in any manner. Return it to an Authorized Service center for inspection, repairing and testing.

Close supervision is required when any appliance is used by or near children.

Disconnect the cord from the outlet before cleaning.

Unplug heater by grasping plug and pulling it from the outlet. NEVER YANK ON CORD.

When store your heater, keep it in a cool, dry place.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.

The surface temperature of the flanges is higher, during use, thus closely supervise any children in the area of this appliance.

Do not leave the cable on hot surfaces.

Do not use outdoors.

If malfunctions happen during operation, please put it to nearby appointed service center with the maintenance card. Never disassemble it by yourself.

To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

Never use the unit in places which are not flat and unstable.

Do not insert and pull out the plug by wet hands, as this may cause electrical shock.

The heater must always operate in vertical position.

Do not scrap the surface with rod or sharp hard tools, as this may cause deformation and rust because of damage of paint coat.

During use surface temperature of the flanges is perhaps higher, thus do not touch it except handle, knob and the keys.
CAUTION! Do not cover the heater while it is on. This can cause dangerous temperature increase .
ASSEMBLING

Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit.

These are to be attached to the base of the heater using the 4 self-tapping screws provided,
taking care to ensure that they are located correctly in the bottom ends of the heater side moldings
USING APPLIANCE
Never use the unit in place which is not flat, make sure there are no flammable or easy deformed objects within 1m.
The heater is suitable for operation on an A. C. electricity supply having the same voltage as that shown on its rating label.
The unit should be earthed. Do not cover the appliance.
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after having not been used for a long period of time the heaters may emit some smell and fumes. This will
disappear when the heater has been on a short while.

Choose a suitable location for the heater, taking into account the safety instructions above.

Insert the plug of the heater into a suitable socket.

Turn the thermostat knob fully in a clockwise direction to the maximum setting.

When the desired room temperature has been reached, the thermostat knob should be turned slowly anti-clockwise until the thermostat is heard to click off.

After this the heater will keep the air temperature in the room at the set temperature by switching on and off automatically.
CLEANING AND MAINTENANCE

Always un-plug the heater from the wall socket and allow it to cool down before cleaning.

Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.