www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | [email protected]
www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | [email protected]
3
Single mode setup…
(Skip if setting up as Multizon
e)
Select Setup as “Single Zone”
The next step allows the position of the underwater lights to be set around
the vessel. This ensures the lights are sent information in the correct order
and color change in the correct sequence.
To set the positions use the following steps and the example positions
shown below.
“Wink Light” to identify it on the vessel – the
light will flash RGB
Use the diagram above as a guide, edit the
light position relative to the vessel.
Repeat for all Lights and then press Save
Light Set up is now complete! The lights can be controlled from the Lumi-link control panel.
The position of the lights around the vessel can also be setup. This ensures
that sweep mode works in the correct order. (Above water zones do not
require position information but can be set if desired).
Light Discovery Process…
Upon first installation and before choosing single vs multizone, the lights connected to the Lumi-link network need
to be discovered.
Perform these steps on first use or if new lights have been added or deleted from the Lumi-link network.
Select “Setup” Icon
Select “Preferences”
Select “System Setup”
Selecet “Light Discovery”
The system discovers ALL lights
attached
Check that all lights have been found
Note – if the number of lights found does not match the expected number, check connections and that each light has
power.
