Please read all instructions prior to installation and keep for future reference!
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS
INSTALLATION.
3. SUITABLE FOR DRY LOCATIONS
4. TYPE IC
5. INHERENTLY PROTECTED
Page 2 of 4
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Models TOVE-G-XX
Tove T-Grid
-
Installation Instructions
6
6.1
Prior to joining the sections together, connect electrical connections together. Join to the corresponding connector with the same colored wires.
6.2
Align male section to the female section, if necessary loosen nuts on the bolt brackets. Then insert all brackets into the female section, make sure there is
no gap in between sections, followed by tightening the outer bolts on bolt bracket first. Then tighten the 2 other bolts. Refer to bracket detail above,
washer must be behind bracket to work properly. Finally tighten the set screws on the plate bracket using the provided Allen wrench.
6.3
Secure LED board back into housing and secure the 4 screws back into place. Repeat for all remaining sections.
Bolt Bracket detail
Quick connects
not shown for clarity
6.3
LED module
male
female
plate bracket
bolt bracket
alignment
bracket
set screw
6.1
24VDC
bolt
bracket
nut
washer
secure
end bolts
1st
secure
inner bolts
2nd
low
voltage
ground
line
voltage
dimming
6.1
5
screw
LED module
5.1
Once all sections are installed & set to the proper hanging height from the ceiling. Loosen and remove the 4 screws from the fixture female
section LED module & carefully lower
. Remove from only the sections that will get connected to
(will be secured in the air, due to the safety wire)
the fixture male sections.
LED module
5.1
5.1
electrical quick connects
not shown for clarity
fixture
male section
Joining Continuous Rows together!
fixture
female section
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
REV0.2 04132018
