Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
REV0.0
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Models TAV-XX-XX
Tavan
-
Tavan L, T or X connector installation
Page 12 of 12
Wiring Diagrams
Lutron Ecosystem H-series wire power supply wiring
Lutron Ecosystem 3 wire power supply wiring
driver
3 way
dimming control
hot (blk)
dim hot (org)
neutral (wh)
ground (gr)
rd (+V)
blk (-V)
to line voltage
to LED module
eldoLED 0-10V Dimming power supply wiring
driver
to LED module
to 0-10V
to line voltage
rd (+V)
blk (-V)
line (blk)
neutral (wh)
ground (gr)
0-10V (-)
0-10V (+)
eldoLED Dali power supply wiring
driver
to LED module
to dali
to line voltage
rd (+V)
blk (-V)
line (blk)
neutral (wh)
ground (gr)
DALI (-)
DALI (+)
DALI (-)
DALI (+)
driver
to ecosystem bus
E1 (per)
E2 (per)
hot (blk)
neutral (wh)
ground (gr)
rd (+V)
blk (-V)
to line voltage
to LED module
A.1
Slightly loosen the 2 screws on the junction box, and remove the power supply.
B .1
Run two conduit to the j-box, one for power/control & other for the low voltage fixture. Refer to wiring below for all wiring information.
A
power supply
junction box
A.1
junction box
power supply
conduit for
fixture
conduit for
power/control
B .1
