Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
REV0.0
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Models TAV-XX-XX
Tavan
-
Tavan L, T or X connector installation
standoff
location
marks
anchor
3.1
On the marked location(s), make a hole using a 13/64" drill
bit.
3.2
Insert the anchor into the hole and push completely in.
3.3
Insert wood screw through cap & washer and then tighten to
secure into the anchors.
ceiling
drill
13/64"
drill bit
3.1
3.3
3.3
hole
3.2
3
wood screw
cap
spacer
5
5.1
While one person is holding the fixture, the other person can
slide the coaxial cable end through the clear o-rings, thumb
nut, backplate & crossbar assembly.
5.2
Refer to the wiring diagram on page 12 and make all necessary
connections.
junction box
backplate
crossbar
assembly
fixture
power wire
5.1
Note:
Prior to wiring the desired fixture height must be
determined to cut off any un-necessary wire.
thumb nut
-
5.2
strain
relief
coaxial
cable
5.1
o-ring
4
Prior to installing fixture to power, coaxial cable
must be prepared to go inside crossbar assembly.
If this step if skipped coaxial cable metal sleeve
will tangle up.
1 - while holding the coaxial cable end.
2 - Pull back about an 1-1/2" of the
metal sleeve to expose the wires.
metal sleeve
wires
3 - Cut off 1-1/2" of the wires.
4 - Pull forward the metal sleeve and
twist to make a firmer single wire.
6.1
Insert the wire nut connections into the junction box & align the
crossbar to the junction box holes and secure using the provided
two #8-32 screw.
6.2
Slide the backplate up to the crossbar and secure by hand
tightening the thumb nut into the crossbar.
#8-32 screw
crossbar
backplate
junction box
6.1
6
6.2
+
Page 10 of 12
