Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
7.1
Remove the protective film from the diffuser lens.
7.2
Align the edge of the lens to the inside of the channel. Followed by
carefully pushing and snapping into the other side little by little until its
completely installed.
5
5.1
Extrusion are not waterproof. If it is going to be installed
Optional:
facing up and in a wet location, drainage holes should be drilled
along the inner corner of the channel every 12". Drill 1/16" to 1/8"
diameters holes before installing LED strip.
12.00"
corner drainage hole
corner
drainage
hole
5.1
4.1
F.OT. Flex or LineLED can be shortened by cutting along the dashed lines
in between the solder pads. Make sure the cut is made on the side of the
F.OT. Flex or LineLED without the wire leads. F.OT. Flex or LineLED cannot
touch the metal endcap which will shorten the circuit.
wire leads
4
3.1
channel
9.1
Ensure the correct (wattage & voltage) power supply is used to power
LineLED. Then proceed to connect LineLED wires from channel to power
supply. For more information please refer to power supply and LineLED
wiring instructions.
9
line voltage wires
low voltage wires
class II power
supply
LineLED of
channel
9.1
8.1
add silicone to the endcaps &
If channel is going to be installed outside,
the full length of the lens. To help avoid getting water inside the channel,
but will not make waterproof.
endcap
silicone
dispenser
Note:
Reference step 8 first if installing outdoors. Then return
back to this step to install lens properly.
lens
7.1
7
7.2
channel
protective
film
lens
CH-MD-LS-SF & CH-MD-TL-SF Channel
-
Installation Instructions
Models CH-MD-LS-SF-XX & CH-MD-TL-SF
Page 2 of 2
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
REV0.0 03092020
solder pads
F.O.T. FLEX
cut
4.1
6
6.1
Prior to installing LineLED to channel, clean channel from any debris.
Gently push LineLED onto aluminum channel and then install endcaps at
both ends.
feed
wire leads
F.OT. Flex or LineLED
through the endcap opening
remove paper backing on the
adhesive tape of the LineLED
before installing to the channel
6.1
endcap
8
9.1
9.1
9.1
silicone
dispenser
