Enable/Disable Allow config
(L)
. When disabled, users will not be able to reach the web-UI on
this IP address.
In the Group/Trunks window
(F)
select the group for the system interface you wish to use.
With the group selected, click the group assignment on the system interface
(M)
.
Network ports:
Depending on the configuration chosen for the interfaces we now need to assign the correct groups/
trunks to the Ethernet ports of the LumiCore.
Select the group or trunk you wish to assign in the Group/Trunks window
(F)
.
With the group selected, click the Ethernet port you wish to assign to this group.
Repeat these steps for the second Ethernet port if required.
In the image on the previous page, the example shows that we have assigned an ISL to ETH2, we used the
management group for the system interface, we used group 4 for the input interface and we used group 3
for the output interface. Finally, we assigned group 2 to ETH1 to give the user access to this group on the
front of the LumiCore.
When all the settings are done, click Save
(N)
to apply the configuration.
Enter the new IP address in your web browser to refresh the page.
3 | ConfIGUratIon
20
