INSTALLATION GUIDE FOR
TSL9 LED SERIES
RETAIN THESE INSTRUCTION FOR FUTURE USE
One Lithonia Way, Conyers GA 30012 | 1.800.705.SERV (7378) |
| © 2020 Acuity Brands Lighting, Inc. All rights reserved.
Page
3
of
3
INSTALLATION PROCEDURE
1.
Remove Luminaire from carton and inspect for damage.
2.
Remove End Caps.
3.
Remove Lens via 8-32 screws.
4.
Remove LED Board Assembly by loosening (2) ¼ hex screws.
5.
Disconnect the LED Board Assembly from the Driver wires, set aside.
6.
Mount Fixture to surface using (4) ¼ bolts (not included).
7.
Connect all supply wires in accordance with national and local electrical codes.
8.
Connect the LED Board Assembly to the Driver wires
9.
Re-install LED Board Assembly using (2) ¼ hex screws. Do not over tighten.
10.
Re-install Lens.
11.
Re-install End Caps.
12.
Energize and test.
13.
Adjust sensor sensitivity as required, see included Watt Stopper instructions.
Sensor Controls
Lens
Endcap
