9
After Sales Support
Telephone:
1300 886 649
Instructions (Cont.)
Using the steam button and the steam lock
1. Press the steam button underneath the handle for short bursts of steam.
2. Press and pull down the steam lock on top of the handle for continuous
steam (Fig. 4).
3. Press and push up to release the steam lock (Fig. 5).
Figure 4
Figure 5
2
1
2
First time ironing
1. Place the iron steam station on a flat, firm and stable surface.
2. Fill the water tank with tap water according to the instructions on page 8.
3. Unwind and straighten the power cord, then plug the steam station into a
suitable power point and switch on the power at the outlet. All LED lights
turn on for a second with an audible beep sound, then they turn off to
indicate the unit is turned on.
4. Press the selection button once, the MAX steam level indicator will glow red
and the power indicator will blink to indicate the appliance is preheating.
5. Turn the temperature dial on the iron to the desired temperature.
6. When the set temperature is reached, the red power indicator will stop
blinking and change to green, followed by a beep sound.
7. The pilot light goes off when the required temperature for the iron is reached.
The appliance is now ready for use.
8. Press down the steam button for 1 minute to clean the steam generating system.
9. Begin first time ironing with an old towel to avoid staining your garments, as
any oils left over from the manufacturing process may be expelled through
the steam holes on the soleplate.
NOTE:
If you press the steam button when the steam generator has not yet
reached its required temperature, the unit will beep twice to indicate it is not
yet ready. It takes about 1½ minutes to reach the required temperature.
