REV. 02/26/2020 PN:
PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
AQUARIUS DECK 5010
B
E
C
D
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
1)
Snap the three post ends into the
step, making sure that the cylindrical
part is vertical and that the ends are
snapped properly in their respective
housings.
2)
Snap the filler post end into the step
as shown.
3)
Snap the two feet to the bottom of
the step.
FILLER
1)
Fill the bag provided with sand.
The approximate weight should
be 5 lbs.
*SAND
1)
Slide the two tie
wraps in place and
place the sand bags
into the riser.
2)
Fasten the tie wraps.
Do not overtighten.
1)
Insert the two step cups in the riser.*
2)
Place the riser on the ground, install the step
on top of the riser and fasten with the four
screws and plastic screw caps provided.
3)
Snap the screw caps covers in place.
F
G
1)
Insert the two posts into the post ends and
secure them in place with the screws provided
(as seen in step H).
2)
Insert the deck support over the rear post.
3)
Insert the handrail on the two posts and
secure in place.
4)
Fasten the access panel with the screws
provided.
3
1
/
4
”
1/4”
align screws from
center of plate
1)
Slowly submerge the
step into the pool. Make
sure you do not damage
the pool liner in the process.
2)
Angle the whole step
so that it is entirely under
water. Purge all the air from
under the steps.
*Sand not included
x13
D
x2
E
D
4x
4x
* View step cups installation tips on YouTube:
https://www.youtube.com/watch?v=W5RH1VNxpu0
