Attaches
REV. 15/04/2019
1) Disconnect the solar panel.
2) Unlock the solar panel from the mounting plate
and slide the panel out as shown.
3) Pull the step and light out of the water for
storage.
B
E
C
1)
Install the battery as per above instructions, making
sure that the panel is pointing toward the sun at noon.
2) Connect the panel to the light fixture according to the
drawing above, screw the connector sleeve
completely to seal the connector properly.
3)
Secure the electrical cord to the tubular post with
the two tie wraps provided.
Make sure that the cable is
routed away from the bathers. Keep the connectors
out of water.
Mounting
plate
*Locate and
orient the panel
properly for
optimal results.
Step A
Step B
Connection of cable
D
User guide
Press on the switch for 4 seconds to turn on or off
the light fixture.
A built in countdown timer will turn off the light after
2 hours.
The light will last for 3 hours on a fully charged
solar panel.
The light fixture is not designed to turn itself on at
sundown.
2257, Route 139
Drummondville, Qc.,
Canada J2A 2G2
WWW.INNOVAPLAS.COM
INNOVAPLAS
To take apart
Push
Pull
DECK INSTALLATION*
STEP COMBO INSTALLATION*
WINTERIZING
TIE
WRAP
1) Identify the best location to install the solar panel.
The panel should be pointing toward the sun at
noon. Avoid major obstacles between the sun and
the panel. The panel should be exposed to a light
source for a minimum duration of 6 hours to perform.
2) Install the mounting plate with the screws and flat
washers supplied. A pictogram engraved on the
mounting plate will help you orient the panel
correctly.
3) Slide the panel housing into the mounting plate,
making sure that the panel is secured by the locking
tab.