Lumi Industries LumiForge, Руководство пользователя

Страница: 22 / 28

- The red cross is made of 1 cm* 1 cm squares. In case you notice that your cross is bigger or
smaller than what it should be, you can apply “Zoom +/-“ to correct it.
- When making a printing preview, if you notice that your part is not perfectly inside the
printing area you can adjust it using “Offset X/Y” and “Rotation”, pressing for each one the
key -/+.
- If you want to save these settings for next uses click on File dropdown menu at the upper left
side of the program screen, choose “setting”.
- Click on “Get Values from Actual” on the bottom left side of the window which has just
opened, then “Save” and “Close”.
5.3 Levelling
the printing
carriage
- Fill the printing vat with resin so that the level is higher than the part you want to print and
position the carriage as mentioned in point 4.5
WARNING: always wear protective gloves and goggles when using the resin. They may cause skin,
eye and respiratory system irritation, and skin sensitization/allergic reaction by skin contact.
ATTENTION: As photosensitive pigments tend to deposit after a while, stir the resin well before
each print, in order to avoid colour spoiling.
IMPORTANT: the level of the resin MUST be at least 1 cm higher than the height of object you are
about to print
-
Now using the first two keys (A and B) on Lumiforge front panel (n.7) you can make the
carriage go up and down together with the projector (img.19.b). Use these commands to
move the carriage without loosing the calibration setting that have just been set.
- Position the carriage right at resin level (img.19.c).
- Once you press “start printing” the carriage will move up automatically so that during the first
layers the carriage will be a little bit higher than resin level, allowing a perfect adherence of
the model.
Img.19 Levelling the printing carriage.
- Pressing the second two keys (C and D) on the right of the frontal panel (n.7) it is possible to
move up and down only the carriage.