Lumel RE81, Руководство пользователя, Страница: 16 / 24

16
EN
4.1. Programming of controller parameters
The pressure and holding down the button during ca 2 sec. cau-
ses the entry in the programming matrix. The programming matrix can
be protected by an access code. In case when giving a wrong value of
the code, it is only possible to see settings through – without the possi-
bility of changes.
The fig 8. presents the transition matrix in the programming mode.
The transition between levels is carrying out by means of and
buttons and the level selection by means of the button.
After selecting the level, the transition between parameters is carried out
by means of
and buttons. In order to change the parame-
ter setting, one must proceed acc. to the section 6.3. “ setting change ”
(see full version of service manual, available at www.lumel.com.pl) .
In order to exit from the selected level, one must transit between pa-
rameters until the symbol [. . .] appears and press the
button.
In order to exit from the programming matrix to the normal working
mode, one must transit between levels until the symbol [. . .] appears
and press the
button.
Some controller parameters can be invisible – it depends on the current
configuration.
The table 1 (see full version of service manual, available at www.lumel.com.pl)
includes the description of parameters. The return to the normal wor-
king mode follows automatically after 30 seconds since the last button
pressure.