Apply the measured quantity to the meter and select the measuring
range prior to activating the MIN/MAX function. With the function
activated, you can select the measuring ranges only manually, if you
switch to another range, the stored MIN/MAX values are cleared. After
Pressing MIN/MAX(3) for the first time, sub-display shows maximum
value. Sub-display shows minimum value, when it is pressed again.
Main-display always shows current value in MIN/MAX mode. To exit
from this mode press and held MIN/MAX(3) button for longer than one
second or when the function selector switch (6) is operated, or when the
meter is turned OFF and ON again. Pressing HOLD(8) in MIN/MAX
mode makes the meter stop updating the maximum or the minimum
value.
Note
MIN/MAX function is available in all the ranges of measurement except
in Hz.
8.Peak measurement
Multimeter 616 provides Peak hold function to capture the maximum or
minimum peak value. To enter peak mode, press PEAK(2) push button
for less than 1 second. A self-calibration process will execute
automatically before normal peak-hold operation. In peak mode, main-
display shows current value of signal, and sub-display shows PMAX or
PMIN value which is selected by PEAK key. After pressing PEAK(2)
push button for the first time, sub-display shows PMAX value. Sub-
display shows PMIN value, when PEAK(2) push button is pressed
again. To exit PEAK-hold function, press PEAK key more than 1 second
or when the function selector switch (6) is operated, or when the meter
is turned OFF and ON again.
9. Voltage measurement
According to the voltage to be measured, set the function selector
switch (6) to VAC or VDC. function selector switch (6) to VAC or VDC.
Connect the test leads as shown. The “ ” socket should be connected
to the lowest potential ground available. In VAC mode main display
always shows voltage and sub display shows frequency.
Note
The 660 mV measuring ranges can only be selected manually with the
“AUTO/MAN’’ (4) push button
Caution
Ensure current measuring range ( “mA’’ or “A’’) is not selected while
voltage measurement ! When the cut-out rating of the fuses is exceeded
because of incorrect operation, a dangerous situation exists!.
9
