Lumberjack WB1620, Инструкция по безопасности и эксплуатации

Страница: 8 / 11

WB1620 06
ASSEMBLY
15. Once the Vice Screw and Washer are removed,
slide the Vice into the three holes on the side of the
Workbench. Once the Vice is threaded into the holes
halfway, use the Hex Wrench to tighten the screws
on either side of the Vice’s center thread.
16. Use the Vice handle to thread in the Vice all the
way and reinstall the Vice Screw and Washer. This
will keep the Vice locked on place on the side of the
Workbench.
17. Use the Drawer Screws (22) to fasten the Drawer
Handles (21) to the Drawer Front Panels (16).
Note: Each Drawer piece should have a sticker
designating what it is (P1-P5). Use the Parts List as on
page 10 as reference. This will help assure correct
assembly.
18. Fasten the Drawer Panel (18) and the Drawer Slot
Panel (19) to the Drawer Front Panel.
19. Fasten the Drawer Back Panel to the ends of the
two side Panels. Then slide the Drawer Bottom (20)
into the grooves along the insides of the side panels,
making sure the felt side is up.
20. Fasten Drawer Bottom to Drawer Pack Panel. Once
Drawers are fully assembled, verify that the inside
tracks along the Sliding Partition are pushed forward.