Lumberjack SS406, Инструкция по безопасности и эксплуатации

Страница: 9 / 21

Dust Blower Assembly
‐ Screw the flexi‐hose on to the opening as
above.
Fixing to a Workbench.
‐ The best way to fix this scroll saw to a work
bench is as above. Please note these fixings are
not supplied.
1. Saw Body
2. Foam Rubber Base
3. Work Bench
4. Flat Seal
5. 7mm Washer
6. 6 mm Hex Nuts
7. 6mm Lock Nut
8. 6 mm Hex Screws
Operation
A scroll saw is fundamentally a “curve cutting
tool “but which can also carry out straight and
angled edge-cuts. Familiarise yourself with the
following important points prior to
commissioning the saw.
‐ The saw does not automatically cut wood.
You must feed the wood against the saw blade
manually.
‐ The cutting process occurs only while the blade
is moving downwards.
‐ Feed the wood slowly against the saw blade as
the saw blade teeth are small and cut only while
moving downwards.
‐ All persons carrying out work with the saw
require training. The saw blade may break easily
during this training time while the operator is
still unfamiliar with the saw.
‐ The saw is best suited for sheets of wood less
than 2.5 cm thick.
‐ Feed the wood especially slowly against the
blade and avoid abrupt curves to prevent the
saw blade from breaking, if you wish to cut
wood sheets thicker than 2.5 cm.
‐ Saw blade teeth become blunt over time, saw
blades must be replaced. The saw blades are
sufficient for 1/2 to 2 operating time depending
upon the type of wood.
‐ Try and make sure that the saw blade follows
the grain of the wood in order to obtain a clean
cut.
SS406 07
ASSEMBLY & OPERATION