Lumberjack SS406, Инструкция по безопасности и эксплуатации

Страница: 8 / 21

SS406 06
ASSEMBLY
Avoid unintentional starting of the
machine. During assembly and for all
work on the machine, the power plug
must not be connected to the mains
supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the
machine and the accessories provided.
Before starting the operation of the machine
for the first time, check if all parts listed in the
box content section have been supplied.
Note:
Check the power tool for possible
damage. Before further use the machine,
check that all protective devices are fully
function. Any lightly damaged parts must be
carefully checked to ensure flawless operation
of the tool. All parts must be properly
mounted and all conditions fulfilled that
ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Setting the Angle Scale.
‐ Loosen the tilt lock, and bring the table
perpendicular to the saw blade using a set
square
(B)
.
‐ Tighten the tilt lock to hold the table in this
position.
‐ Set gauge
(C) to zero.
Note
– the bench should not be on the
motor block as this causes excessive
noise.
Blade Guard and Clamp Assembly.
‐ Insert the work piece holder
(A)
into the clamp
(B) , then tighten bolt (C) .
‐ On to the top of Clamp
(B)
assemble the blade
guard as in the image above.