Lumberjack SCMS254SB, Инструкция по безопасности и эксплуатации

Страница: 11 / 24

AIR6V 01 AIR6V 01 AIR6V 01 AIR6V 01
SCMS254SB 09
OPERATION
Operation
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note: Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Bench Mounting
The saw base has holes in each corner to
facilitate bench mounting.
1. Place the saw on a level, horizontal bench or
work table using bolts (not supplied) and fix the
saw to the bench using 4 bolts.
2. If desired, you can mount the saw to a piece
of 1/2” (13 mm) or thicker plywood which can
then be clamped to your work support or moved
to other job sites and re-clamped.
CAUTION. Make sure that the mounting surface is
not warped as an uneven surface can cause
binding and inaccurate sawing.
Release knob
The release knob (2) is provided for holding the
cutting head down while transporting or storing
the mitre saw. The saw must never be used with
the release knob locking the head down.
Mitre table locks
The mitre table locks (18) are used to lock the
table at the desired mitre angle.
The mitre saw cuts from 0° to 45° both left and
right. To adjust the mitre angle loosen the mitre
table locks(18)(19) and rotate the mitre table to
the desired position.
The mitre table features positive click stops at 0°,
15°, 22.5°, 30° and 45° for quick setting of
common mitre angles.
Bevel lock
The bevel lock (10) is used to set the blade at the
desired bevel angle. The mitre saw bevel cuts from
0° to 45° to the left. To adjust the bevel angle
loosen the bevel lock and adjust the saw arm to
the desired bevel angle.
Spindle lock button
The spindle lock button (20) prevents the blade in
the saw from rotating. Depress and hold the
spindle lock button while installing, changing, or
removing the blade.
Rotating lower blade guard
The rotating lower blade guard (6) provides
protection from both sides of the blade. It retracts
over the upper blade guard (4) as the saw is
lowered into the workpiece.