Lumapower EDC LM 21, Руководство пользователя

Страница: 3 / 4

Digital output control
Half press to cycle the output from Low, Medium and High.
At each output level, with a full press to lock it.
You can change the output by power off and on.
The power off status over 5 seconds will restore the output status to low output with your
next start.
Battery Installation
Unscrew the Head housing and insert new battery with positive ends towards LED assembly.
Replace bezel and hand tighten. Depress tailcap pushbutton switch to test.
Note: It would not light if battery is inserted in wrong direction.
Mechanical polarity protection will protect the circuit from wrong battery insertion.
CAUTION:
EDC LM 21 flashlights are high-output lighting devices. Due to possible
eye injury, DO NOT look directly into the reflector when the light is switched on.
S
afety is your responsibility, too.
External surface temperature will rise during prolonged operation; this is a normal operating
phenomenon.
Battery Replacement
If there is significant decrease in brightness of light output you should replace the battery.
Unscrew the Head housing and remove the old battery. Insert a new battery as mentioned in
Battery Installation Guide
WARNING:
Lithium batteries can explode or cause burns if disassembled, shorted,
recharged, exposed to water, fire, or high temperatures. Do not place loose batteries in a
pocket, purse or other container containing metal objects or store with hazardous or
combustible materials. Store in cool, dry, ventilated area. Follow applicable laws and
regulations for disposal.
Maintenance
Clean and lubricate threads with a clean cloth and apply thin coat of silicon-based lubricant to
rubber O-rings. Note: Do not use petroleum-based lubrication on O-rings. After prolonged
exposure to moisture, the bezel and batteries should be removed, inspected, and dried if
necessary
.
WARNING:
Lumapower reflector is made with high precision process. Do not touch
or clean the reflecting surface using any cloth which may cause damage to the surface
material affecting the illuminating performance.