67
VENTUS 2.0 Manual / Updated 2013/2/15
/ Operational Manual
VENTUS 2.0
Selection Area of Ensemble Set No.
- Ensemble Status View Area, Service View Area and SSC View Area about selected Ensemble set No. is loaded.
Ensemble Status View Area
- Mode, Total Bit-rate, Status, File Path of the selected numbers on Ensemble Set are displayed.
- Depending on the status of Mode, ‘Mode Not defined’, ‘Service Mode’, ‘Ensemble Mode’ is displayed.
- Status of Ensemble is displayed as ‘Usable’ or ‘Unusable’.
Service View Area
- Belonging to the selected settings of each service in Ensemble Set, ‘Service Type’, ‘Service ID’, ‘Service Name’,
‘Destination IP Address’, ‘Destination UDP Port’, ‘Bit-rate’ are displayed.
- Loading File (Ensemble or Service)
- “Click right mouse -> Click Insert” (Service or Ensemble file can be loaded.)
- In Service Mode, user can load additional service files “Click right mouse -> Click Insert”
(To remove service, do “Click right mouse -> Click Delete”
- Service ID, Service Name, Destination IP Address can be edited by ‘mouse left-click’ in the area.
And if edited value is not allowed, the value returns to its previous value. Edited value immediately applies to the
SSC View area table.
SSC View area
- SSC tables(SMT, SLT, CIT, GAT) display. (RRT will be supported)
- In Ensemble mode, SSC tables show when the information is already included in the file (SMT is a mandatory
table, another table may not exist in the file.)
- In Service mode, the SMT, SLT is automatically built.
- In Service mode, Component Descriptor in the “SMT Table – Service – Component” must input the hex values
about codec information.
Ensemble GUI – Feature on Each Area (1)
Ensemble GUI – Feature on Each Area (2)
Ensemble GUI – Feature on Each Area (3)
4
5
6
