Ludlum Measurements 195271, Руководство пользователя

Страница: 20 / 45

MODEL 2000 Technical Manual
Section 6
Ludlum Measurements, Inc. Page 6-1 November 2020
Data Output
he Ludlum Model 2000 RS-232 serial port can be connected to a
computer or printer for data logging of the scaler count
information. Windows™-based software and cable are supplied
with the instrument. The computer software can control the count
time, start and stop counting, time/data stamp data, and print or save data.
An optional printer may also be purchased to print each scaler reading.
The two-pole dipswitch on the rear chassis underneath the calibration cover
controls the RS-232 data. The bottom switch (
PC
/
PRNTR
) controls the type
of data. In
PC
mode, data is bi-directional, allowing the computer to
start/stop counting. In the
PC
mode, the count time can also be changed by
the computer, but only if the count time push-wheels are set to “000”. In
the
PRNTR
mode, the scaler count is output at the end of each count only.
The top switch (
RECYC
/
OFF
) allows counting to recycle instead of requiring
a manual push of the
COUNT
button for each cycle. This mode is useful with
the optional printer for taking many separate counts.
Software
PRIOR TO INSTALLATION OF SOFTWARE
Ensure that both the computer and the Model 2000 are turned
OFF
.
Connect one end of the supplied RS-232 cable to the Model 2000 and
connect the other end of the cable to any unused serial port on the back of
the computer. (This unused port should be labeled COM1, COM2, COM3,
or COM4.)
INSTALLATION OF SOFTWARE
1. Insert LMI Model 2200/2000 Software CD into the CDROM
drive. Setup will automatically start. If it does not, double-click
on the “setup.exe” file located on the CD.
Section
6
T