LUCKYSMART LBT-1, Руководство по эксплуатации

Страница: 9 / 32

8
2） A bait boat with a groove for installing the probe in
the hull (No. 2 rubber sleeve)
There is a groove at the bottom of the bait boat for installing probes. LBT-1-GPS
comes with aappropriative No. 2 rubber sleeve . The installation steps are basical-
ly the same as in 1 above. The only difference is that the probe needs to be cover-
ed inside the rubber sleeve, so that it can be fully matched with the probe installa-
tion groove reserved on the boat.
3) A bait boat with a groove for installing the probe in the
hull (No. 3 rubber sleeve)
There is a groove at the bottom of the bait boat for installing probes. LBT-1-GPS
comes with aappropriative No. 3 rubber sleeve . The installation steps are basica-
lly the same as in 1 above. The only difference is that the probe needs to be cove-
red inside the rubber sleeve, so that it can be fully matched with the probe install-
ation groove reserved on the boat.
probe installation Introduction
1) Use a screwdriver to remove
the probe decorative cover
from the bottom of the ship.
2) Assemble the probe and ru-
bber pad, and pass the assem-
bled probe through the probe
hole.
3) Tighten the probe with the
lock knob inside the boat.
4) The installation is completed.
Probe
Lock knob
No. 2 rubber sleeve
1
2
4