300 SERIES
ADJUSTABLE BASE
OWNER'S MANUAL
17
16
Synchronizing Two Bases
PROBLEM
POSSIBLE SOLUTION
No features of the base will activate.
Ensure the remote is paired correctly with the
base
(see pages 14-15)
.
Unplug the power cord, wait 30 seconds and
plug back in to reset electric components.
The surge protection or the electrical outlet
may be defective. Test the outlet by plugging
in another working appliance.
Head or foot section will elevate, but will
not return to the flat position.
Bed mechanism may be obstructed. Elevate
bed and check for obstruction. Remove
obstruction.
Head section may be too close to the wall.
Head and Foot lift function has minor
interference during operation.
Check batteries in wireless remote control.
Replace with two (2) new AAA batteries if
necessary.
Make sure that you are following the duty
cycle of the motors (do not operate more
than two (2) minutes over an eighteen (18)
minute period.
Wireless remote may be experiencing
common radio frequency interference from
other radio transmitting devices. Wait several
seconds and try pressing appropriate button
again. See FCC Compliance Statement
(page 5)
.
Base has lost power and will not lower.
Press the blue pairing button located on the
control box cord for emergency lowering.
Troubleshooting
OVERVIEW
Two Twin XL bases may be placed next to each other to form a
King. Both sides can be operated independently with their own
remotes or, if desired, a single remote can be paired to both
bases. Pairing a single remote to both bases will result in the
bases moving jointly.
TO PAIR ONE REMOTE TO TWO BASES:
STEP 1
Ensure both bases (A & B) are plugged into a power source.
STEP 2
Make sure Remote A was already paired to Base A and Remote
B was paired to Base B. If not, pair them by following the
instructions found on pages 14-15.
STEP 3
After remotes are paired to their respective bases, pair Remote
A to Base B
(see pages 14-15).
Both bases can now be operated
by Remote A.
Only one remote can be paired to both bases.
