2
The lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user of the presence
of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the product (i.e. this manual).
Caution
To prevent electric shock, do not use the polarized plug supplied with the unit with any extension cord, receptacle, or other
outlet unless the blades can be fully inserted.
Terms
Several notational conventions are used in this manual. Some paragraphs may use Note,
Caution
, or
Warning
as a heading or certain typefaces and capitalization are used to identify certain words. These are:
Note
Identifies information that needs extra emphasis. A Note generally supplies extra information to help you
to better use the product.
Caution
Identifies information that, if not heeded, may cause damage to the Lucid product or other equipment in your system.
Warning
Identifies information that, if ignored, may be hazardous to your health or that of others.
C
APITALS
Controls, switches or other markings on the product's chassis.
Equipment Markings
O
PERATOR
S
AFETY
S
UMMARY
AVIS:
NE PAS OUVRIR
Il ne se trouve a l’interieur aucune piece pourvant entre reparée l’usager.
SEE OWNERS MANUAL. VOIR CAHIER D’INSTRUCTIONS.
S’adresser a un reparateur compétent.
RISQUE DE CHOC ELECTRIQUE
No user serviceable parts inside. Refer servicing to qualified service personnel.
CAUTION
WARNING:
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE
DO NOT OPEN
RISK OF ELECTRIC SHOCK
Important Safety Instructions
Please read and keep these instructions. Heed and follow all warnings and instructions.
Mains Voltage Selection
The Line Voltage selector switch is located near the IEC power inlet
connector. Set it to correspond to the nominal AC mains voltage
used in your studio. The amperage of the fuse changes depending on
the setting of the Line Voltage selector switch. (You must change the
fuse to correspond with the new amperage.)
The fuse ratings are listed later in this section.
Power Source
This product is intended to operate from a power source that does
not apply more than 250V rms between the power supply conductors
or between either power supply conductor and ground. A protective
ground connection, by way of the grounding conductor in the power
cord, is essential for safe operation.
Grounding
The chassis of this product is grounded through the grounding
conductor of the power cord. To avoid electric shock, plug the power
cord into a properly wired receptacle before making any connections to
S
ECTION
2
